CNC plasma cutting machine is mainly composed of beam, base, lifting body, control system, worktable, plasma power supply. Here are the main components of the next CNC plasma cutting machine:
Solenoid valve is an industrial equipment controlled by electromagnetism. It is an automatic basic component used to control fluid. It belongs to actuator. Pneumatic solenoid valve is one of them. It blocks or leaks different oil drain holes by controlling the movement of valve body. The oil inlet hole is normally open, and hydraulic oil will enter different oil drain pipes, Then the oil pressure of the pneumatic solenoid valve pushes the piston of the oil cylinder. In this way, the mechanical movement of the whole solenoid valve is controlled by controlling the current of the electromagnet of the pneumatic solenoid valve.
Characteristic Pneumatic Solenoid Valve, Pneumatic Air Solenoid Valve, Electronic Solenoid Air Valve Glove Industry Co.,Ltd. , https://www.gloveind.com
1. Beams: Beams are an important part of the balance and lateral cutting of the cutting machine. It belongs to the airframe itself. Cutting guns while working, moving horizontally and cutting.
2. Base: The part is located on the guide rail, under the crossbeam, with a roller at the bottom. This component is mainly used to move the device longitudinally and perform cutting action.
3. Lifter: This part is adjacent to the torch and is located on the crossbeam. It is mainly used to move the torch up and down, but it can be processed on plates that do not know the thickness.
4. Control system: It is the command center of the entire CNC plasma cutting machine. It is mainly used to set the relevant parameters such as the trajectory of the CNC plasma cutting machine.
5, table: that is, the foundation header. It is a necessary device for the CNC cutting machine to work. It is mainly used for plate placement and cooling work during equipment work. (usually done by customers themselves)
6, plasma power: plasma cutting machine to provide power, plasma cutting machine is an essential accessory.
Chinese cutting machine trading network, allowing you to buy the rest assured! A variety of CNC cutting machine and CNC cutting equipment, a variety of cutting machine models, let the optional! Official website: /
It can work normally under vacuum, negative pressure and zero pressure, but its diameter is generally less than 25 mm.
It can also operate under zero pressure difference, vacuum and high pressure, but it has high power and must be installed horizontally.
The upper limit of fluid pressure range is high, which can be installed arbitrarily (need to be customized), but the condition of fluid pressure difference must be met.
Principle editing voice
There is a closed cavity in the pneumatic solenoid valve, and there are through holes in different positions. Each hole of the pneumatic solenoid valve leads to different gas pipes. There is a valve in the middle of the cavity and two electromagnets on both sides. The valve body will be attracted to which side when the magnet coil is electrified;
The pneumatic solenoid valve blocks or leaks different exhaust holes by controlling the movement of the valve body, and the air inlet is normally open. High pressure gas will enter different exhaust pipes, and then push the piston of the cylinder through the air pressure of the pneumatic solenoid valve. In this way, the mechanical movement of the whole solenoid valve is controlled by controlling the current of the electromagnet of the pneumatic solenoid valve.
Operation principle of pneumatic solenoid valve
We said the pneumatic solenoid valve working position (solenoid valve on or off), in fact, refers to the pneumatic solenoid valve spool position.